Config portal

Accessing Config portal:

A) Local network

You can access the clock on your local network simply by entering it's IP address. You can find the IP in your router's list of devices or you can enable "Show IP address after reset" option in the Config portal. This will show last segment of the clock's local IP address. This option is very helpful and I suggest to have it enabled so you don't have to search for the address in your router.

B) Access point

If the clock can't connect to your wifi or the wifi credentials are not set, it will fall into Config mode for 5 minutes. See https://github.com/mcer12/Nick2-Nixie-Clock/wiki/First-run for more. If it reaches the timeout, clock will fall into Failed mode with red light on. To start config portal again, simply disconnect and reconnect power.