Skip to content

1.7
Compare
Choose a tag to compare
@prasimix prasimix released this 01 Jul 13:35
· 348 commits to master since this release
1.7
b666d7f

A simple function generator has been added in this release (#198). The data logger (DLOG) can now work with multiple channels and supports the sampling rate of the MIO168 module as well as the addition of a bookmark. UART (DIN1 / DOUT1 pins on the front panel) now allows communication with other devices but also control of BB3 using SCPI commands (#19). Two additional protection mechanisms have been added for the DCP405 module (#195, #202).

  • #19 SCPI via UART
  • #20 Add support for timestamped text in DLOG
  • #42 Add support for MIO168 module
  • #45 Add support for PREL6 module
  • #128 MQTT can't connect to broker without authentication
  • #152 Checking the firmware target on the on-board MCU
  • #155 Ambiguous error message about high temperature
  • #156 Firmware download warning message
  • #157 USB issue with OTG cable connected
  • #164 DISP:TEXT doesn't display last character from the string
  • #169 Feature Request: Option to hide recording status window
  • #171 Clear DLOG REMark and X axis label when DLOG is started through GUI
  • #174 Step menu allows negative delay setting with encoder
  • #176 DLOG view doesn't remember settings
  • #178 Dlog window at bottom of screen causes flashing at the top
  • #180 Add hold delay on Lock display option
  • #182 Set execution time for the route:close and route:open SCPI commands
  • #183 The GUI Shutdown option does not turn off AC power
  • #184 Pinout page
  • #185 Add support for MUX14D module
  • #188 Disable IRQ inputs for empty slots or modules in error state
  • #191 DCM224: displaying current below zero
  • #192 Calibration via GUI
  • #194 Change various defaults
  • #195 Down-programmer sinking limit
  • #198 Programing LIST refactoring (i.e. function generator)
  • #199 Generate Ethernet MAC address from MCU serial number
  • #200 Change the User SW function if the channel outputs are in INHibit mode
  • #202 Continuous checking of output voltage on DCP module
  • #203 "Wrong thread 6" message when limit is set below set level via SCPI and GUI (volt or current) on DCP405
  • #204 Display connection diagram for coupled DCP modules
  • #205 CapReform fixes
  • #206 Reorganizing the status bar
  • #208 AUX temp sensor trip does not change color
  • #209 Wrong calibration params displayed on DCM CH2
  • #211 Remove all minimized views
  • #219 Popup indication when changing the display view
  • #221 Add indication of current range selection on DCP module
  • #222 System trigger refactoring
  • #223 OE on ramp adjustment
  • #229 Add tolerance for OCP trip level
  • #232 Full scale: Auto doesn't display YT-view correctly
Assets 4
Loading