A simple simon game setup to run on an Arduino Uno
By @TheCaptain
This can probably run on any arduino, but I only tried it on the UNO
Arduino IDE is suggested for compiling and uploading code to the arduino board
to download Arduino IDE go to https://www.arduino.cc/en/software
-1 Arduino Uno
-1 SPDT OR SPST switch
-4 SPST push-button switches
-4 LED's preferably of different colors
-2 100 ohm resistors
-1 10K ohm resistor
-1 five volt power regulator
-2 4026B seven-segment drives (optional)
-2 seven-segment displays (optional)
-? hookup wire
-1 USB cable
while seven-segment displays for score keeping aren't necessary, I really suggest it
all power is routed through a SPDT switch and a 100 ohm resistor and than through a five volt power regulator (it doesn't matter what kind)
leds are hooked up to arduino outputs 2, 3, 4 and 5 on long leg and short leg to ground
buttons are hooked up to arduino inputs A0, A1, A2 and A3 and power through a 10K ohm resistor
output 12 goes to pin 1 on a 4026B seven-segment drive chip, which is than carried to another 4026B and than to two seven-segment displays
4026B's are powered through a 100 ohm resistor