v2.0.0

Firmware for the factory test. This is NOT READY for production!

The test instructions are basically the same as the previous years.

1. Download the attached swadge2024-firmware_3e1dea0.zip
2. Run pyFlashGui.py (see README.md for python requirements & usage).
3. Plug a Swadge into the computer using a USB-C cable while the 'up' button is held down and the power switch is in the USB position
4. Wait for flashing to finish
5. Reboot the Swadge and complete the test steps to validate hardware with test mode

Note

Due to DMA limitations, the speaker and microphone cannot be tested at the same time. The test steps have been adjusted so that the speaker is tested first, and the microphone is not tested until after the buttons, touchpad, and IMU tests have all passed. This means the microphone must be tested last.

Prior year's video instructions can be referenced, as the process has not changed much.

• Last year's video instructions)
• Two year's ago video instructions