v2.0.0

Firmware for the factory test. This is NOT READY for production!

The test instructions are basically the same as the previous years.

1. Download the attached swadge2024-firmware_3e1dea0.zip
2. Run pyFlashGui.py (see README.md for python requirements & usage).
3. Plug a Swadge into the computer using a USB-C cable while the 'up' button is held down and the power switch is in the USB position
4. Wait for flashing to finish
5. Reboot the Swadge and complete the test steps to validate hardware with test mode

Note

Due to DMA limitations, the speaker and microphone cannot be tested at the same time. The test steps have been adjusted so that the speaker is tested first, and the microphone is not tested until after the buttons, touchpad, and IMU tests have all passed. This means the microphone must be tested last.

Prior year's video instructions can be referenced, as the process has not changed much.

• Last year's video instructions)
• Two year's ago video instructions

Snapshot

Latest Development Snapshot

v1.1.0

What's Changed

• Added documentation by @AEFeinstein in #196
• Add Bedrock and Pixel to the credits by @Brycey92 in #197
• Fix flight sim for portal by @cnlohr in #198
• Added tinter tool by @AEFeinstein in 8c48c63

Full Changelog: v1.0.1...v1.1.0

Release Firmware

This is the firmware shipped to Elecrow for manufacturing.

Firmware Freeze

This is the firmware freeze release. We've got two weeks to test before release, but no major additions are allowed past this point

Test Firmware for Factory

This firmware is just to test the first run of hardware at Elecrow