Home

Introduction

• The Utah Geological Survey uses a series of steps to process transducer data into usable water elevations.
• This tool is meant to standardize the processing of these data.

Processing options

There are two processing options one can use:

• Single-Well Process
  • process one transducer file
  • this is good for troubleshooting individual wells partially processing a file
  • barometric data that are measured over a similar time period are required.
• Bulk Well Process
  • Process an entire folder with well files
  • Table of manual measurements is required for this
  • Bulk processing requires more setup and information, but can process many files quickly

Graphs and Tables

The graph and table capabilities seen in the right-hand side of this application are based on the pandastable library.

Farrell, D 2016 DataExplore: An Application for General Data Analysis in Research and Education. Journal of Open Research Software, 4: e9, DOI: http://dx.doi.org/10.5334/jors.94

These features were designed for the impressive dataexplore application designed by Farrell. Instructions for use of some of the features and buttons can be found in the dataexplore help files.