Add Olimex ESP32-PoE-ISO Board with DIY LoRa Board #192
Conversation
This file contains bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
Add LAN Support for Olimex
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
Add this suggestion to a batch that can be applied as a single commit.
This suggestion is invalid because no changes were made to the code.
Suggestions cannot be applied while the pull request is closed.
Suggestions cannot be applied while viewing a subset of changes.
Only one suggestion per line can be applied in a batch.
Add this suggestion to a batch that can be applied as a single commit.
Applying suggestions on deleted lines is not supported.
You must change the existing code in this line in order to create a valid suggestion.
Outdated suggestions cannot be applied.
This suggestion has been applied or marked resolved.
Suggestions cannot be applied from pending reviews.
Suggestions cannot be applied on multi-line comments.
Suggestions cannot be applied while the pull request is queued to merge.
Suggestion cannot be applied right now. Please check back later.
I was looking for a POE Lora Igate solution to be able to operate the receiver directly on the radio mast without an antenna cable.
Since I couldn't find anything, I developed a solution myself.
I have developed a board with the Olimex UEXT standard that fits the expansion port and can be found here:
https://github.com/dl1lmh/LoRa-Board-for-Olimex-UEXT
When the board is flashed, the AP is started first so that configuration is possible as usual.
If you activate the "Use LAN Instead" switch, the WiFi is switched off and the board starts in LAN mode. Then it gets an IP address via DHCP and works as usual, everything should work with LAN. The configuration page can also be accessed via LAN.