[fi] Update crypto_aes_encrypt test name in CI

Signed-off-by: Pascal Nasahl <[email protected]>

fault_injection/configs/test.yaml

@@ -0,0 +1,58 @@
+target:
+  target_type: chip
+  fw_bin: "../objs/chip_pen_test_fi_silicon_owner_sival_rom_ext.img"
+  target_clk_mult: 1
+  target_freq: 100000000
+  baudrate: 115200
+  output_len_bytes: 16
+  protocol: "ujson"
+  port: "/dev/ttyUSB1"
+  # Trigger source.
+  # hw: Precise, hardware-generated trigger - FPGA only.
+  # sw: Fully software-controlled trigger.
+  trigger: "sw"
+  usb_serial: "205F355C3236"
+fisetup:
+  fi_gear: "dummy"
+  fi_type: "voltage_glitch"
+  # Parameter generation.
+  parameter_generation: "random"
+  # Number of randomized iterations for the parameter sweep.
+  # For parameter_generation: "random", this is the number of iterations.
+  # For parameter_generation: "deterministic", this is the number of iterations
+  # per fixed parameter.
+  num_iterations: 100
+  # Voltage glitch width in ns.
+  glitch_voltage_min: 2.7
+  glitch_voltage_max: 3.3
+  glitch_voltage_step: 0.05
+  # Voltage glitch width in ns.
+  glitch_width_min: 5
+  glitch_width_max: 150
+  glitch_width_step: 3
+  # Range for trigger delay in ns.
+  trigger_delay_min: 0
+  trigger_delay_max: 500
+  trigger_step: 10
+fiproject:
+  # Project database type and memory threshold.
+  project_db: "ot_fi_project"
+  project_mem_threshold: 10000
+  # Store FI plot.
+  show_plot: True
+  num_plots: 100
+  plot_x_axis: "glitch_voltage"
+  plot_x_axis_legend: "[V]"
+  plot_y_axis: "glitch_width"
+  plot_y_axis_legend: "[ns]"
+test:
+  # which_test: "crypto_aes_key"
+  # which_test: "crypto_aes_plaintext"
+  which_test: "crypto_aes_encrypt"
+  # which_test: "crypto_fi_aes_ciphertext"
+  expected_result: '{"ciphertext":[141,145,88,155,234,129,16,92,221,12,69,21,69,208,99,12],"alerts":0,"err_status":0}'
+  # Set to true if the test should ignore alerts returned by the test. As the
+  # alert handler on the device could sometime fire alerts that are not
+  # related to the FI, ignoring is by default set to true. A manual analysis
+  # still can be performed as the alerts are stored in the database.
+  ignore_alerts: True