This implements the procedure described in the Kernel's gadget_configfs.txt as a system unit.
If you're running on a Pi, you will first need to enable the appropriate device overlays:
-
If you plan to use your USB port as both a host and a gadget, then enable OTG mode by adding the following to
/boot/config.txt
:dtoverlay=dwc2,dr_mode=otg
-
If you will be operating exclusively as a gadget, then instead use:
dtoverlay=dwc2,dr_mode=peripheral
After editing /boot/config.txt
, you must reboot for the changes
to become active.
To install the systemd unit, run make install
in the source
directory, which will place the support scripts into /sbin
and the
systemd unit into /etc/systemd/system
.
Create one or files in /etc/gadget
named <gadget_name>.conf
.
These files must contain the following configuration keys:
USB_FUNCTIONS
-- List of functions implemented by the gadget.
These files may contain any of the following configuration keys:
USB_IDVENDOR
-- Vendor ID. Defaults to0x1b6d
, the Linux Foundation.USB_IDPRODUCT
-- Product ID. Defaults to0x0104
, "Multifunction Composite Gadget"USB_BCDDEVICE
-- Device version. Defaults to0x0100
(for 1.0.0).USB_BCDUSB
-- Maximum supported USB version. Defaults to0x0200
(for USB 2.0).USB_SERIALNUMBER
-- Device serial number. Defaults todeadbeef0000
.USB_PRODUCT
-- Product name. Defaults toPi Zero Gadget
.USB_MANUFACTURER
-- Manufacturer name. Defaults toLinux
.USB_MAXPOWER
-- Maximum power required. Defaults to250
.
For example, to create a serial gadget named g0
, I would create the
file /etc/gadget/g0.conf
with the following contents:
USB_FUNCTIONS=acm.usb0
Or to create a gadget that offered both a serial interface and an ethernet interface:
USB_FUNCTIONS="acm.usb0 rndis.usb0"
To enable the gadget at boot, run:
systemctl enable usb-gadget@g0
To create the gadget immediately:
systemctl start usb-gadget@g0
To remove the gadget after starting it:
systemctl stop usb-gadget@g0