Service which enables communucation for HomA based controllers with CAN bus devices. It's originally designed to be used with Wiren Board smart home, and uses extended MQTT conventions.
Now bridge supports Hapcan relays only, but can be extended easily to all Hapcan units and maybe some other CANbus devices. (It's only matter of bus communication dumps and API, 'cause I don't have any devices except those relays).
Target build with wbdev wbdev make.
For tests run make ifup (from root) for dummy interface and use candump, cansend.
Cli flags are:
- -p - mqtt port (default: 1883)
- -h - mqtt host (default: localhost)
- -v lvl - verbose level 0-4 (default: 0)
- CAN bus doesn't have any scan ability, so in general some config needed. But not now - Hapcan supports scan frame. Service send scan frame on startup to obtain device list. Config may appear later (on demand).
- Bistable relay can save own On-Off state. The question is where is verified state while unsync (on power loss for example). Now it is on relay side.