This is a P8X32A/Propeller, P2X8C4M64P/Propeller 2 driver object for Texas Instruments CC1101 low-power ISM-band (sub-1GHz) RF transceiver.
IMPORTANT: This software is meant to be used with the spin-standard-library (P8X32A) or p2-spin-standard-library (P2X8C4M64P). Please install the applicable library first before attempting to use this code, otherwise you will be missing several files required to build the project.
- SPI connection at up to 1MHz (P1), ~5MHz (P2)
- Over-the-air (OTA) data rate from 600 Baud to 500kBaud
- 2FSK, 4FSK, GFSK, ASK/OOK, MSK modulation formats
- Set common RF parameters: Receive bandwidth, IF, carrier freq, DC block filter, RX Gain, TX power, FSK deviation freq, channel spacing
- Set number of preamble bytes
- Set function of CC1101's GPIO pins
- Address filtering
- Options for increasing transmission robustness: Data whitening, Manchester encoding, FEC, syncword
- RSSI measurement
P1/SPIN1:
- spin-standard-library
- P1: 1 extra core/cog for the PASM SPI engine (none if bytecode-based engine is used)
P2/SPIN2:
- p2-spin-standard-library
| Processor | Language | Compiler | Backend | Status |
|---|---|---|---|---|
| P1 | SPIN1 | FlexSpin (6.9.4) | Bytecode | OK |
| P1 | SPIN1 | FlexSpin (6.9.4) | Native/PASM | OK |
| P2 | SPIN2 | FlexSpin (6.9.4) | NuCode | OK |
| P2 | SPIN2 | FlexSpin (6.9.4) | Native/PASM2 | OK |
(other versions or toolchains not listed are not supported, and may or may not work)
- TBD