-
Notifications
You must be signed in to change notification settings - Fork 73
ESP8285 ESP M2
The WiFi module ESP-M is manufactured by using a high-performance chip ESP8285. This small chip is encapsulated an enhanced Tensilica’s L106 diamond series 32-bit kennel CPU with a SRAM. Thus, ESP8285 has the complete function Wi-Fi function; it not only can be applied independently, but can be used as a slaver working with other host CPU. When ESP8285 is applied as a slaver, it can start from the onboard Flash. The built-in high-speed buffer is not only benefit to improve the system performance, but optimize the store system. In addition, ESP8285 can be used as Wi-Fi adapter by SPI/SDIO or I2C/UART interface, when it is applied to other MCU design. The ESP-M module supports the standard IEEE802.11 b/g/n/e/i protocol and the complete TCP/IP protocol stack. User can use it to add the WiFi function for the installed devices, and also can be viewed as a independent network controller. Anyway, ESP-M module provides many probabilities with the best price.
- SOC characteristics
- Built-in Tensilica L106 ultra-low power consumption 32-bit cpu, the main frequency can be 80MHz and 160MHz, also support RTOS;
- Built-in TCP/IP protocol stack;
- Built-in 1 channel 10-bit high precision ADC;
- The outside interfaces have HSPI, UART, I2C, I2S, IR Remote Control, PWM, GPIO;
- The deep-sleep current is about 10uA, and the cut-off current is smaller than 5uA;
- Can be wake-up within 2 ms, and connect to transmit data package;
- the consume power is smaller than 1.0mW (DTIM3) when at standby status;
- built-in 1M byte for SPI Flash.
- Wi-Fi characteristics
- Support 802.11 b/g/n/e/i
- Support three modes: Station, SoftAP, and SoftAP+STA;
- Support Wi-Fi Direct(P2P);
- Support hardware acceleration for CCMP (CBC-MAC, computation mode), TKIP (MIC, RC4), WAPI(SMS4), WEP(RC4), CRC;
- P2P find, P2P GO mode/GC mode and P2P power management;
- WPA/PA2 PSK and WPS;
- Support 802.11 i security: pre-certification and TSN;
- Support 802.11n (2.4 GHz);
- 802.1h/RFC1042 frame encapsulation;
- Support seamless roam;
- Support AT remote updation and cloud OTA updation;
- Support SmartConfig function for Android and iOS device SmartConfig.
- 2*UART;
- 1*En;
- 1*ADC;
- 1*wakeup pin;
- 1*HSPI;
- 1*I2C;
- 1*I2S;
- MAX 10* GPIOs;
- Working temperature: -40℃-125℃
- Module size:
- 12.3mm15mm; (M1 version)
- 12.3mm20mm; (M2 version)
- Serial Transparent transmission;
- Smart power plug/Smart LED light;
- Sensor networks;
- Wearable electronics;
- Securit ID label;
- Wireless location recognition;
- Wireless location system beacon;
- Industrial wireless control.
- WiFi prober;
- Mesh networks;
Shenzhen Doctors of Intelligence & Technology Co. Ltd: wwww.doit.am, SZDOIT official online Shops: www.vvdoit.com, and www.smartarduino.com
- Preface
- Start to Play ESP8266
- ESP-F
- ESP-F1
- ESP-F2
- ESP-E
- ESP-01
- ESP-01s
- ESP-07
- ESP-12E
- ESP-12F
- ESP-S
- DT-W5G1
- DMP-L1
- DMP-P1
- ESP-M1
- ESP-M2
- ESP-M3
- ESP-M4
- ESP-1
- ESP32
- ESP32U
- ESP32-C2
- NRF24l01
- Preface
- NodeMCU
- miniNodeMCU
- WiFi Shield
- ESPduino
- 2-way&16-way motor&servo shield
- ESP32
- DT-06(TTLtoWiFi)
- ESPDuino-32
- 2/4ch DC motor & 16ch servo shield---motor and servo shield
- Preface
- Video
- Softwares
- Motors & Servos
- Assembling Chassis
- Wireless WiFi Tank Car
- Wireless WiFi Video Tank Car
- RC Robot
- Preface
- Humanoid
- Gripper/Claw
- Robot Arm
- 3dof Robot Arm
- Visual Programming blocks