DNE Change Log

DO NOT EDIT

Table of Contents Version 1.1 (in Development) Version 1.0.2 – Jan 7, 2015 Version 1.0.1 – Dec 28, 2014 Version 1.0.0

Version 1.1 (in Development)

• Reduced code size, depending on your configuration.
• Danish language.
• LCD Probe Z Offset now shows the actual (usually negative) offset value.
• Improved support for Delta, SCARA, and COREXY kinematics.
• Move parts of Configuration files to Conditionals.h and SanityCheck.h.
• Clean up of temperature code.
• Fix handling of invisible files. Files and folders starting with underscore are now visible.
• Enhanced G29 with improved grid bed leveling based on Roxy code. See documentation.
• EEPROM layout updated to V21.
• Short EEPROM output as G-Code – Replay to restore settings.
• Added M204 travel acceleration options.
• Added S0 option to M503 for pure G-code output.
• M204 "P" parameter replaces "S." ("S" retained for backward compatibility.)
• Support for more RAMPS-based boards.
• Support for Mega Controller and Minipanel.
• Configurator utility (in the early stages of development).
• M404 "N" parameter replaced with "W." ("N" is for line numbers only).
• Much cleanup of the code.
• Improved support for Cyrillic and accented languages.
• Fix M303 so it doesn't swallow commands while running.
• LCD controller knob acceleration.
• Improved compatibility with various sensors, MAX6675 thermocouple.
• Improved support for M110, with or without the extra N parameter.
• Filament runout sensor support.
• Filament width measurement support.
• Support for TMC and L6470 stepper drivers.
• Improved support for Texas Instruments DRV8811 stepper drivers.
• Support for the SSD1306 Monochrome 128X32 I2C OLED Graphic Display.
• Better support of G-Code ; comments, \, N line numbers, and * checksums.
• Moved GCode handling code into individual functions per-code.
• Only one "cold extrusion prevented" message per command.
• Fixed lcd display of Volumetric Multiplier, to show percent rather than scaling value.
• Preliminary support for M111 with debug flags TBD.
• Support for Repetier DEBUG_DRYRUN flag via M111.
• Added FAN_MIN_PWM configuration option with fan-speed scaling.
• Various bugs existing in 1.0.2 have been addressed.

Version 1.0.2 – Jan 7, 2015

• Fixed: #1038 Steppers were disabled during filament change
• Display Z position on LCD without leading and trailing zeros
• Fixed: #1315 DOGLCD and LCD_PROGRESS_BAR conflict

Version 1.0.1 – Dec 28, 2014

• Progress bar for character-based LCD displays.
• SD Card folder diving up to 10 levels deep.

Version 1.0.0

• 1.0.0 was not tagged officially. This number applies to any Marlin before the 1.0.1 release.