Intro

This Fork from DeuxVis, supports OLED display on the I²C interface on GPIO22 and GPI21. This repo contains a patched SSD1306 library from smartnick, enabling individual I²C pins and to set I²C Clock to 800kHz.

This is a simple sketch demonstrating the capability of the TTGO T-Beam as a TTN Mapper Node on The Things Network LoraWAN.

Derived from sbiermann/Lora-TTNMapper-ESP32 and with some information/inspiration from cyberman54/ESP32-Paxcounter and Edzelf/LoRa.

Please look also at the repo from Heinrich Hottarek which gives you some additional features.

!!Only for hardware Version up to V07!!

Software dependencies

Arduino IDE ESP32 extension

TinyGPS++

LMIC-Arduino : Make sure to get the last version - 1.5.0+arduino-2 currently - because the arduino IDE library updater is getting confused by the versioning scheme of that library.

Instructions

You need to connect the T-Beam DIO1 pin marked Lora1 to the pin 33 - So that the ESP32 can read that output from the Lora module. Optionally you can also connect the Lora2 output to GPIO 32, but this is not needed here.

You can program the T-Beam using the Arduino ESP32 board 'Heltec_WIFI_LoRa_32'.

On The Things Network side, the settings needed are available here.

Configure the Payload decoder with:

function Decoder(bytes, port) {
    var decoded = {};

    decoded.latitude = ((bytes[0]<<16)>>>0) + ((bytes[1]<<8)>>>0) + bytes[2];
    decoded.latitude = (decoded.latitude / 16777215.0 * 180) - 90;
  
    decoded.longitude = ((bytes[3]<<16)>>>0) + ((bytes[4]<<8)>>>0) + bytes[5];
    decoded.longitude = (decoded.longitude / 16777215.0 * 360) - 180;
  
    var altValue = ((bytes[6]<<8)>>>0) + bytes[7];
    var sign = bytes[6] & (1 << 7);
    if(sign)
    {
        decoded.altitude = 0xFFFF0000 | altValue;
    }
    else
    {
        decoded.altitude = altValue;
    }
  
    decoded.hdop = bytes[8] / 10.0;

    return decoded;
}

Let me know if more detailed instructions are needed.

Todolist

• Stop sending data to TTN until the GPS get a fix. <== Done thanks to @Roeland54
• Manage and document the different T-Beam revisions/versions.
• Switch to OTAA auth method for TTN and save the 'credentials' for reboot use.
• Save and reload the frame counter somewhere - GPS RTC data ? SPIFFS ? EEPROM ? - so I can check the "Frame Counter Checks" box as recommended on TTN.
• Also save the GPS 'status' so that on next boot it gets a fix faster.
• Reduce the power needed ! That thing is a power hog currently, we need to make it sleep most of the time as possible.
• Adapt the data send frequency based on current velocity : When not moving, an update per hour should be enough.

Let me know if you think anything else would make sense for a TTN mapper node : Open an issue, I will consider it.