Replies: 1 comment 9 replies
-
|
Is it a model that already has Wi-Fi? In that case I'm afraid it won't work. At least that's what I have heard from some people |
Beta Was this translation helpful? Give feedback.
-
|
@visualapproach On instruction I see 10K ohms but on the V2B board is writed that I should use ~560 Ohms and 200pF Cap what is correct for this setup? |
Beta Was this translation helpful? Give feedback.
-
|
Both. As printed on the PCB you use the R1/10K if you have "the blue" level converter. Nothing to do with the filters that should have around 560 Ohms. |
Beta Was this translation helpful? Give feedback.
-
|
still the same behavior, pump panel is not working :( any ideas how to debug this ? local wire test is also OK for all pins.
|
Beta Was this translation helpful? Give feedback.
-
|
also app UI is not working correctly, buttons are not working the same as in this picture from project |
Beta Was this translation helpful? Give feedback.
-
|
How is the ui not working? 404 error or just that the buttons don't do anything? |
Beta Was this translation helpful? Give feedback.
-
Hi, I had Hawaii Hydrojet Pro S200102 6 wires and setup PCB_V2B + red LLC, no resistors, software from release v4.2.3, and config as below on screens:
The temperature is not correct, touch panel is not working, running buubles is working but with big delay ( the button is not stay in position ON after push but pump is starting after few seconds od delay ) any ideas what need to be checked?
also hardware test is OK
Beta Was this translation helpful? Give feedback.
All reactions