maldive 2021 don't turn on

[mulroux95]

Good morning all,
I have a 6 wire maldive. I programmed the ESP8266 and I manage to connect to it. My problem is that when I connect the card to the SPA, then the ESP 8266 lights up and you can connect to it in WIFI. However, the spa display remains off and the spa does not start. when I reconnect the spa without the card, it starts normally. Ideas ?

i use eric pbc

[visualapproach]

Good evening, to check hardware go to hwtestinfo.html. Also check that you defined the correct model and pcb as shown in the instructions.

[mulroux95]

hello, Thank you for your answer.
I did the test and everything is wrong.
I have a doubt about my welding of 8 channel.

[visualapproach]

Feel free to post images of your device and your model.h

[mulroux95]

[visualapproach]

What buttons? Web gui buttons usually takes one or two seconds before action. The display buttons should be immediate.

[mulroux95]

The web gui buttons.

[visualapproach]

Have you tried waiting a bit? Bad Wi-Fi? What's the rssi?

[mulroux95]

Rssi between -75 & -77. What ' s this value?
Thanks you

[visualapproach]

No problem, thank you for your kindness!
RSSI is Wi-Fi strength value and -75 is on the low side (closer to zero is better). See if it works better by putting the router closer. Mine is fine with rssi -60 but it's not an absolute value so you should experiment a little