New supported model: S100103, Lay-Z Helsinki

[hubaksis]

Module S100103, Lay-Z Helsinki is working.
It's 6 wire, I used 510 Ohm resistors (instead of suggested 560 Ohms resistors between LLC and display (CLK, DATA, CS), as
reported by cyberfly79).
The module is connected to MQTT/Openhab. I don't use web interface at all.
The only noticed issue for now - sometimes when I switch the temperature, it sets 20 instead of the value I chose. I faced the issue only a couple of times, so hard to reproduce.

[kgreene1983]

how did you mount this to the unit?

[hubaksis]

There is a WiFi option in these units, and the cost is $100 more. Not sure what are the features though.

[visualapproach]

@hubaksis the development branch now has a new method of setting the temperature. Should be more reliable but a little bit slower to get to the new target temperature.

[kgreene1983]

Just wondering why you need to add the resistor?

[hubaksis]

As per discussion here: #54
Also https://github.com/visualapproach/WiFi-remote-for-Bestway-Lay-Z-SPA/blob/master/Build-instructions-Bestway-WiFi-remote.pdf at the third page "Might need 560Ohm resistors between LLC and display (CLK, DATA, CS) as reported by cyberfly79"
I haven't checked without them, just used them straight away.

[kgreene1983]

thanks for the info.

I'm using the PCB, could someone tell what pins (6 wire) I need to add the resistors too?