Octoprint Micro Panel screen went blank...

[kingsman-lab]

Hi all, I'm sorta new to the Raspberry Pi world and had been using OctoPrint on my Pi Zero 2 W with the Adafruit 128x64 1.3" OLED Bonnet. I also had been using the OctoPrint Micro Panel and it had worked really well in the past until I updated to the latest software. I ended up re-imaging to latest OctoPi thinking that maybe if I could re-image to the latest OctoPi that I could get OctoPrint MicroPanel to work again. I'm currently on OctoPrint 1.10.1 with Python 3.9.2 and OctoPi 1.0.0 build 2024.05.14.100113, and now I can't get my Micro Panel to work. I followed all of your steps of enabling I2C and checked that the display shows 3c when ran the i2cdetect -y 1. It worked before so I re-imaged the microsd card with the latest OctoPi and went through your instructions. Still nothing shows up on my OLED screen. I tried another install with using the Adafruit OLED buttons.py to test if it's my OLED and it works fine but not on OctoPrint. I even tried installing a fresh Octoprint on my spare Pi 4B and again went through your instructions and it doesn't work on there too. So I'm stumped. Any help would be awesome! Attached is the octoprint.log

octoprint.log