ESP32-CAM not working

[Stoupa77]

Hello
I bought two ESP32-CAM cameras, and I set them up according to the instructions for connecting to PrusaConnect and the cameras are running. When I connect to their wi-fi it works, when I add it to my network it runs. I can also see it on http://prusa-esp32cam.local. I add it to PrusaConnect. The camera appears there. It shows me what wi-fi it is connected to, what IP it has, but it does not send an image (the image is not available) - instead there is only a crossed out image of the camera. It does not show either one, it always stays at the same point. The camera update is checked.
As soon as I turn off the camera and return to it the next day, it logs in to my wi-fi, but I can no longer access it via the PC, it is no longer displayed at all. But it sends information to PrusaConnect. It shows the IP address, but I cannot connect to the IP of the camera. Only to the camera's wi-fi and then through it, but nothing else.
Please can you advise me where the problem is, why it doesn't work?

Thank you for the advice?

[johnyHV]

Hello @Stoupa77 . Have you tried turning on the camera and letting it run for, for example, 90 seconds, without trying to connect to the camera via WiFi?

Or can you insert to the camera micro SD card, and then send me a log file? You can add logs here to git. Passwords are not displayed

[Stoupa77]

Hello @johnyHV

Yes, I tried it for a longer time, when I didn't even touch the camera, but the effect was the same.
I'll try putting a card in it when I get to it again and send the log.

[fftkatarn]

Same behaviour here, camera is present on my printer page with all the network parameters but no photo is shown.

[Stoupa77]

Hello.

I am attaching the log info in the attachment. I had to delete the camera again, flash it and set a new token on prusa connet. Then it failed because I accidentally clicked on authorization and had to flash it again and put the token again. Now it only works on the IP address and I can only access it there. In Prusa Connet it reports itself as registered, but nothing is displayed. There is only a crossed out image of the camera (picture). Now I will let it run, for example for an hour. Then I will turn it off and tomorrow I will not be able to access it even on the same IP address as it has today.

PRUSA CONNECT IMAGE

LOG INFO
Log info.txt

[johnyHV]

It's strange. And on the camera WEB interface can you see photo ? Can you try using the latest FW version? I've just released it, it's FW 1.1.1. I don't think it will help. But we can try it.

[Stoupa77]

I did the update, but nothing changed, as you wrote. It loads the photo normally on the page, but nothing is sent to Prusa Connect. The camera has been running for about 4 days without turning off and is not sending anything anymore.