[BUG] Enclosure fan not running after print completion

[zehkaiser]

Printer model

XL 5T

Firmware version

6.1.3+7898

Upgrades and modifications

Enclosure

Printing from...

USB via Prusa Link

Describe the bug

The enclosure fan turns off immediately following print completion despite the Post Print Filtration option being enabled with Post Print Filtration Duration set to "5 min." The heat break fan shows "100% / stuck," but I'm not sure if that's normal without the enclosure. You can hear the fan spin down in the video.

Prusa.Encolsure.Turns.Off.mp4

How to reproduce

Enable the enclosure filtration fan and enable Post Print Filtration with a duration of 5 minutes. Allow a print to complete.

Expected behavior

Enclosure filtration fan should run for 5 minutes before shutting off.

Files

No response

[CZDanol]

Hey,
would you mind trying to update the FW to 6.2.0 to check if it hasn't been already fixed?

Also, the heatbreak fan should definitely not be saying it's stuck, I'd recommend checking it out. Does it do that for other tools, too?

[zehkaiser]

I updated the firmware and printed on Tool 2. Both tool fans now say "0% / stopped," but the enclosure fan still shuts off as soon as the print has completed. Tomorrow I'll run another print on Tool 1 to see what the fans say after the print completes.

[zehkaiser]

The heatbreak fan showing as "100% / stuck" is isolated to tool 1. It behaves the same as tool 2, though, running at 100% until the tool cools and it ramps down to eventually 0.