config.txt

# Default Nerves RPi 4 config.txt
#
# It's possible to override this file by using a custom fwup.conf
# configuration to pull in a replacement.
#
# Useful links:
# http://rptl.io/configtxt
# https://www.raspberrypi.org/documentation/configuration/device-tree.md
# https://github.com/raspberrypi/documentation/blob/master/configuration/device-tree.md
# https://github.com/raspberrypi/firmware/blob/master/boot/overlays/README

# We always use the same names. The variant is selected in fwup.conf.
start_file=start4.elf
fixup_file=fixup4.dat

# Disable the boot rainbow
disable_splash=1

# This, along with the Raspberry Pi "x" firmware is needed for the camera
# to work. The Raspberry Pi "x" firmware is selected via the Buildroot
# configuration. See Target packages->Hardware handling->Firmware.
gpu_mem=192

# Enable I2C and SPI
dtparam=i2c_arm=on
dtparam=spi=on

# Enable audio (loads snd_bcm3825)
dtparam=audio=on

# Automatically load overlays for detected cameras
camera_auto_detect=1

# Automatically load overlays for detected DSI displays
display_auto_detect=1

# Enable DRM VC4 V3D driver
dtoverlay=vc4-kms-v3d
max_framebuffers=2

# Don't have the firmware create an initial video= setting in cmdline.txt.
# Use the kernel's default instead.
disable_fw_kms_setup=1

# Run in 64-bit mode
arm_64bit=1

# Disable compensation for displays with overscan
disable_overscan=1

# Run as fast as firmware / board allows
arm_boost=1

# Comment this in or modify to enable OneWire
# NOTE: check that the overlay that you specify is in the boot partition or
#       this won't work.
#dtoverlay=w1-gpio-pullup,gpiopin=4

# Support USB gadget mode on the USB-C port
dtoverlay=dwc2

# The ramoops overlay works with the pstore driver to preserve crash
# information across reboots in DRAM
dtoverlay=ramoops

# Enable the UART (/dev/ttyAMA0)
enable_uart=1