Missing Cooling electrical sensors?

[ando2040]

I've deleted the integration, recreated the credentials (I think I was still on 'temporary application' - not any more) but the Cooling electrical sensors are still missing from just one of my splits - in fact they've now been removed from HA altogether. Any ideas please? As you can see from history (before I first removed the integration), they were present until mid-April.

EDIT: if you don't have https://github.com/SpangleLabs/history-explorer-card - it's brilliant!

[jwillemsen]

Is the sensor maybe renamed? Check all entities under the device in the settings? If it is not the case enable debug log and attach it here with the integration diagnostics, see readme

[jwillemsen]

Supported operation modes are only fanOnly and heating, no cooling as far as I can tell from the data

[ando2040]

Bloody hell you're right - cooling has disappeared from that unit in Onecta. I did have an engineer round to look at an issue - I wonder if he's hard set it at the pump for diagnostic purposes.

It's still available for the other 4 units on the pump.

[jwillemsen]

Please contact the engineer to learn what he did, not sure what happens, but as Daikin doesn't report cooling consumption this integration can't export it to HA

[ando2040]

Fair enough this isn't your issue. Thanks for spotting the issue is Daikin's

[ando2040]

I worked out what the Daikin engineer did. He didn't realise himself, the effect of what he'd done.

He executed a whole page in the manual, when I believe he should have started halfway down. The objective was to correct the offset in heating mode, so that 20C target gets closer to 20C and not 15C!

I posted more detail here, without understanding for myself what part above does! Will update with advice.
https://community.home-assistant.io/t/daikin-climate-personalised-sensor/249729/6?u=ando2040