This is a list of all parts required to build a complete Galagino cabinet from plywood. Further instructions are linked below.
If you don't have access to a laser cutter or prefer a fully 3d printed case then you should have a look at John Bradnam's great Galagino case.
- 38 pin ESP32 Devkit
- 2.8 inch 320x240 ILI9341 display
- mounted on 50mm x 86mm PCB
- no touch screen required
- PAM8302A amplifier
- cased 3W / 8 ohms speaker as seen e.g. in the cabinet photos
- 7 x WS2812B LED stripe
- 7 LEDs cut from a 144 LEDs per meter stripe
- four 6mm x 6mm push buttons, through hole, height 4.3mm
- three 6mm x 6mm push buttons, through hole, height 9mm
- ~50 cm 10 wire flat ribbon cable
- 10 pcs M2 x 8mm screws
- 4 for the cabinet, 2 for the coin button, 4 for the speaker
- 6 pcs M2 x 12mm screws
- for the 3D printed control board
- one M2 x 16mm screw
- for the 3D printed control board
- 14 M2 nuts
- 6 for the control board, 4 for the cabinet, 4 for the speaker
- 8 M2 washers
- 4 for the cabinet, 4 for the control board