Replies: 3 comments 2 replies
-
|
It sounds like there is a gpio misconfigured that is used by the ethernet device. |
Beta Was this translation helpful? Give feedback.
-
|
|
Beta Was this translation helpful? Give feedback.
-
|
The GPIO on port 5 is going to cause the Ethernet interface to stop working. You will need to set the GPIO for port 5 to an available pin. |
Beta Was this translation helpful? Give feedback.
-
|
Thank you so much, it's working! |
Beta Was this translation helpful? Give feedback.
-
|
I found a 2nd overlap. I will be uploading an updated GPIO definitions file shortly. |
Beta Was this translation helpful? Give feedback.
-
Hello. I am launching a project on WT32-ETH01 ESPixelStick-v4-1.0 (DDP)
I add objects to the ports in the Visualise tab..., then I Upload Output, everything loads, but when I go to ESPixelStick, only 2 ports are active, not 3 (((( And when I manually add a third port, the ethernet port stops working in ESPixelStick...
Pings disappear and ethernet does not work accordingly. I can only access ESPixelStick via Wi-Fi.
Can you tell me what the problem might be? Or what is the correct PIN to use for the third?
Beta Was this translation helpful? Give feedback.
All reactions