User Guide: FrSKY Sensor Hub

FrSKY Sensor Hub enables your board to send UAVO data to a FrSKY receiver. You have to connect the receiver sensor hub port using a TTL<=>RS232 converter to the flight control.

The following has to be done to enable the module:

1. Create a suitable connection cable with TTL<=>RS232 converter
2. Connect RS232 side to the FrSKY receiver.
3. Connect TTL side to a free uart
4. Map this uart to the FrSKY sensor hub module in hardware settings
5. Enable module in module settings
6. Restart your flight control

The module will send this data to the receiver:

• altitude
• temperatures
• x,y and z accelleration
• current, voltage and cell voltages (if battery module is enabled)
• gps data (if gps module has a fix)