You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I saw that you have added milestone for automated bed leveling, but I was hoping to add a request to also allow access to the manual and mesh bed leveling (G29 Command) that is available in Marlin.
To further clarify... I was able to enable the manual mesh bed leveling by changing changing the configure.h and recompiling. What we need to make this work further is another level of controls in the LCD display that allow for finer adjustments, button tied to G29 S1, G29 S2, and then a button to save the measurements.
I would take a stab at this myself, but I don't understand how to program the LCD display. I am accessing the feature through Pronterface Printrun now.
The text was updated successfully, but these errors were encountered:
This would be a useful additional feature under the Tuning menu. I haven't tried it, but one of the reasons I installed this firmware was to do so.
What would the manual mesh leveling look like? I'm not sure what's involved, but knowing what sort of features the software would require is probably a good starting point.
As a Patreon backer, just wanted to comment that I'm really excited to see that you added this to the 5.0 milestone! I've been excited for manual mesh leveling for a long time. Please take this as a huge support behind the feature!
Feature Request
I saw that you have added milestone for automated bed leveling, but I was hoping to add a request to also allow access to the manual and mesh bed leveling (G29 Command) that is available in Marlin.
To further clarify... I was able to enable the manual mesh bed leveling by changing changing the configure.h and recompiling. What we need to make this work further is another level of controls in the LCD display that allow for finer adjustments, button tied to G29 S1, G29 S2, and then a button to save the measurements.
I would take a stab at this myself, but I don't understand how to program the LCD display. I am accessing the feature through Pronterface Printrun now.
The text was updated successfully, but these errors were encountered: