circuit-analyzor-cellbox

1-Press the "place part" button to add an electrical component to the circuit. 2-After completing the circuit design, press the "analyze" button to get the component current and node voltage. 3-"controlling part" in "palce part" windows is the part of the circuit that controls the current or voltage of the source. 4-The software cannot analyze the location of the nodes, so you must enter the location of the circuit nodes correctly. 5-You may need JDK version 1.8 to run the software not higher or lower version,install it first and place software on "C" drive to run. ///////////////////////////////////////////////////////////////////////////////////////////////// The software is based on the MNA algorithm. The ways to communicate with me Telegram: @cellbox email: [email protected] ////////////////////////////////////////////////////////////////////////////////////////////////