OctoDash - GeeekPi Display - MHS35 driver

[MacEdgar1]

OctoDash setup screen does not show.

Ran new OctoPi with Camera image to SD.
Ran OctoPrint base setup to set up my printer.

OctoPrint 1.9.3
OctoPi 1.0.0
OctoDash Auto-Install
Then installed MHS35 driver
Ran APT updates.

Followed the following:
Double Check that B2 is selected for the Boot Options in raspi-config
Connect a display via HDMI to see if OctoDash is available on the screen connected via HDMI
If you got a guide from your seller instructing you to change some settings (i.e. via raspi-config) - try just installing the driver without doing any of the subsequent steps listed in the guide.
Try reconfiguring your x11 server: sudo dpkg-reconfigure x11-common
Install additional packages, which my be needed for OctoPi distrobutions: sudo apt install libpam0g-dev libx11-dev
Install even more packages: sudo apt install raspberrypi-ui-mods (please try the above first)

HDMI and Screen show the same image. Used the /local/Admin/oprint as local virtual env when asked as I use the Admin account.

Don't know what else to try. The screen works. Did not install the full desktop. Also tried installing driver before everything. Initially had the XINIT could not find a screen so continued to install the other recommended installs to troubleshoot.

Image of current screen:

Image of base install without further insalls.