Crash when adding new Printer

[dasds-cpu]

Cura Version

5.8.1

Operating System

Windows 11

Printer

Felix TEc 4 Dual

Reproduction steps

1. Clicked on Drop-Down Printer Menu
2. Clicked "Add Printer"

Actual results

The Application closes without an Error Message

Expected results

The Menu to add a Printer should have opened.

Add your .zip and screenshots here ⬇️

I dont have more Information

[GregValiant]

Thanks for the report.
I can't duplicate this. Doing the triage here - at any given time I probably have 20 printers installed. I just haven't had this problem on my Win10 system.
Do you happen to have the "StartUp Optimizer" plugin installed? If you do then un-install it and try again. Part of what it does is to hide a lot of the printer definitions from Cura so they don't load.

[fieldOfView]

Part of what it does is to hide a lot of the printer definitions from Cura so they don't load.

But what it doesn't do is let Cura close without an error message.

[dasds-cpu]

I have no PlugIns and only three Printers which all show up ( Felix Tec 4 Dual, Ender 5 Plus and Ultimaker 2 Go) Aldo Hoeben ***@***.***> schrieb am Di., 19. Nov. 2024, 12:48:

…

Part of what it does is to hide a lot of the printer definitions from Cura so they don't load. But what it doesn't do is let Cura close without an error message. — Reply to this email directly, view it on GitHub <#19924 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/BNBJ35WEJGPTFSCZ5ICGTJT2BMQRXAVCNFSM6AAAAABSAL3MKSVHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMZDIOBVGM4DGMZUHA> . You are receiving this because you authored the thread.Message ID: ***@***.***>