No motion binary_sensor

[johannwilken]

Description

I don't have a binary_sensor for motion anymore

Reproduction Steps

no binary_sensor entity under device entities

Expected behavior

I don't have a binary_sensor for motion anymore

If applicable, add error logs.

No errors in logs

Device Firmware

1.0 (1.3.6)

Using stream component

Yes

Does camera work via official integrations?

Yes

Camera has all attributes filled out in developer tools

Yes

HASS Environment

Proxmox VM

Search for similar issues

Yes

Additional information

Binary_sensor was removed round about core version 2023.4

[JurajNyiri]

Firmware 1.3.6 has broken pull endpoint, thanks to new version webhooks can be used which still work.

Check faq for information.

• If you have webhooks enabled, and your Home Assistant internal URL is reachable on HTTP, make sure camera can reach it.
• Make sure you have correct IP set for Home Assistant. Turn on Advanced Mode under /profile. Go to /config/network and under Network Adapter verify correct IP is shown for the device. If it is not correct, under Home Assistant URL uncheck Automatic next to Local Network and set it to http://<some IP address>:8123. DO NOT USE HTTPS.
• Certain camera firmwares have pullpoint broken, with only webhooks working. If you are not able to run webhooks because of above (https, or vlan setup), binary sensor will never show up.

Duplicate of #312 .