Replies: 2 comments 1 reply
-
Hello, |
Beta Was this translation helpful? Give feedback.
-
Dear all, |
Beta Was this translation helpful? Give feedback.
-
Hello, |
Beta Was this translation helpful? Give feedback.
-
Dear all, |
Beta Was this translation helpful? Give feedback.
-
Hello @BonneelP
I hope you can answer my question without affort, ie. studying the code :-)
Now, in ElecLUTdq.run() if there is no enforced LUT a new LUT is calculated. Then the calculated LUT should be set as LUT_enforced (line 89 -
output.simu.elec.LUT_enforced = LUT
).Contrary, e.g. in "tuto_Efficiency_map.ipynb" of PR #558, elec.LUT_enforced is still None after the simulation (without additional affort).
Is this behavior caused by VarSimu due to copying the simulation? But get the var. simulations copied only after the reference simulation? Otherwise each variation would run LUT simulation.
Best regards, Sebastian
Beta Was this translation helpful? Give feedback.
All reactions