Pump plugin updates

[adrianbostan]

I almost finished writing a new plugin for the pump module. I replaced the i2c comm with CanBus and socketcan.
Communication its reliable and there will be some updated to the code.

So far i discovered some issues with the old plugin: All there values are not updating, if values are modified in arduino, they will not be updated in the web page.

There are a few things that i would like to have in the new plugin, but in have no experience with web.py :)
A few boxes with some values like:canbus address,temperature,humidity etc.
This is the repo of the new plugin
Also a box that became green when the module its connected and its working

[Dan-in-CA]

The repo link is not working. -- Never mind I found it. -- Nope it was the Pump control module.
still have not found the Python code.

[adrianbostan]

I sent an invite now, i forgot it was private

[Dan-in-CA]

OK got it.

[Dan-in-CA]

I have the Python file but I will also need the template (HTML) file to get things working.

[adrianbostan]

Its the same HTML as for i2c pump

[adrianbostan]

Some configs will be needed in order to enable the can interface:
https://www.beyondlogic.org/adding-can-controller-area-network-to-the-raspberry-pi/

Maybe its possible to do this from the python plugin

[Dan-in-CA]

It should be possible to do the configs from the plugin.
Python can run Linux commands so the plugin can check if a driver is loaded and edit the config files if needed.