Energy Consumed by day / week / month

[Conair0001]

This is a great project, and everything works very well, right out of the box!

There's one thing that I used to get from EPEVER Wifi provides stat values for Energy consumed (in kWh), there is:

• daily (kWh)
• monthly (kWh)
• yearly (kWh)
• Total (kWh)

Is there a plan to add these measurements as well?
(For me this is important, because I think only the energy that was consumed is actually saved, because only what I consumed I didn't have to get from the electricity provider. And I do see ~50-80kWh difference between generated and consumed per year in my setup. I guess there are losses in the charger, in the battery and so on.).

Another thing that I would wish, there seem to be new datapoints every few seconds, it would be great if it's possible to configure a delay through mqtt, so you can choose to get a new value appx. every 1 minute or something like this.

Thanks a lot!

[Bettapro]

I created issue #83 and #84 for your requests.

The update intervals could be exposed throgh the web configuration (I think you shouldn't change those values so often), is there any reason you want them exposes via MQTT?

[Conair0001]

Hi Alberto,   thanks for looking into this. Yes, I don't plan to change this configuration once things work as expected. Of course through the web configuration would be good as well.   Only reasony why I was asking for MQTT is, that the web configuration isn't available while I'm in my house. Switching the module into configuation mode I have to climb up  under my roof and it feels cumbersome to make simple config changes, then looking at things for few hours, closing the ladder and everything and then notice I have to climb up again after a day or 2 :-) -> probably a luxury problem that only I have in my setup :-) (And only the first few days until things work.)   Maybe it should be possible to keep the web configuration active always, or switch info config mode without having to click the reset button? (I don't expose this module to the internet, so I'm not concerned about security in my setup...)   Thanks for your help in advance.   Best regards, Konrad.     Gesendet: Montag, 26. Februar 2024 um 22:39 Uhr Von: "Alberto Bettin" ***@***.***> An: "Bettapro/Solar-Tracer-Blynk-V3" ***@***.***> Cc: "Conair0001" ***@***.***>, "Author" ***@***.***> Betreff: Re: [Bettapro/Solar-Tracer-Blynk-V3] Energy Consumed by day / week / month (Discussion #82)   I created issue #83 and #84 for your requests. The update intervals could be exposed throgh the web configuration (I think you shouldn't change those values so often), is there any reason you want them exposes vie MQTT? — Reply to this email directly, view it on GitHub, or unsubscribe. You are receiving this because you authored the thread.Message ID: ***@***.***>